3D printed in ABS.
PolyLite™ ABS (Acrylonitrile Butadiene Styrene) is made with a specialty bulk-polymerized ABS resin, which has significantly lower volatile content compared to traditional ABS resins. It delivers excellent printing quality.
After printing we give our parts an acetone vaporisation bath, this gives an ultra smooth finish.
By sandblasting we give the parts a matt finish so printing lines are no longer visible.
Baby Capa kit contains:
The Frame from a 5.1 can be used for this setup. (because a 4.3 frame is longer then 5.1)
Max 90-100 psi
Recommended barrel lenght for the baby capa is PDI 6.01 barrel 91mm.
We have 11 colors to choose from: Black, Dark Blue, Purple, Light Blue, Dark Green, Light Green, Yellow, Orange, Red, Gray and White.
Mention the color of your choice in the comment section.
If you do not, you will recieve Black.
Please note: installing parts / assemble /fitting airsoft gun will need intermediate knowledge; for expert or airsoft gunsmith. Please refer to your airsoft gunsmith for proper installation / fitting. Fitting may be needed as the condition of each airsoft gun might be different.
€110,00 Oorspronkelijke prijs was: €110,00.€100,00Huidige prijs is: €100,00.
Uitverkocht