SRS A1 Adapter M4 Gen2

Repairsoft

3D printed in ABS.

PolyLite™ ABS (Acrylonitrile Butadiene Styrene) is made with a specialty bulk-polymerized ABS resin, which has significantly lower volatile content compared to traditional ABS resins. It delivers excellent printing quality.

After printing we give our parts an acetone vaporisation bath, this gives an ultra smooth finish.

By sandblasting we give the parts a matt finish so printing lines are no longer visible.

TIP: if you wipe the printed parts with a cloth cockpit spray you can get a shiny finish.

3D printed M4 adapter for SRS A1 Sniper designed  by Repairsoft.

Made for PTS magazines

No wobble from adapter to  replica

No wobble from mag to adapter

Perfect fit

Inside the M4 adapter are raised ribs to make the magazine sit tightly.

when filing these down you can make the magazine drop easily.

On top of SRS magazine there is a set screw that holds the bb stop system.

You can adjust this strenght by tightening the set screw, it will hold the bbs more firmly in place.

This because not everyone always uses new magazines, and the strenght of spring from magazine can change after usage.

PTS magazine not included.

We have 11 colors to choose from: Black, Dark Blue, Purple, Light Blue, Dark Green, Light Green, Yellow, Orange, Red, Gray and White.

Mention the color of your choice in the comment section.

If you do not, you will recieve Black.

Please note: installing parts / assemble /fitting airsoft gun will need intermediate knowledge; for expert or airsoft gunsmith. Please refer to your airsoft gunsmith for proper installation / fitting. Fitting may be needed as the condition of each airsoft gun might be different.